| |
Sample Size
|
Diameter: 1.3" (33 mm)
Thickness: 0.0" - 0.8 " (0 - 20mm)
(see note below) |
| Sample Resistance Range |
0.01 K/W - 8 K/W |
| Sample Temperature Range (max.) |
20°C - 65 °C (approx.)
(see note below) |
| Contact Pressure Range |
Kit 1: 5 – 95 psi ( 50 – 650 kPa)
Kit 2: 10–170 psi (100–1100 kPa)
Kit 3: 20–380 psi (100–2600 kPa)
Kit 4 Option: Complete Kits 1, 2, & 3
|
| Contact Pressure Accuracy |
Kit 1: +/- 2.5 psi (2 kPa)
Kit 2: +/- 5 psi (4 kPa)
Kit 3: +/- 10 psi (7 kPa)
(see note below)
|
Sample Thickness
Electronic-Measurement Range |
0.00" - 0.35" (0 - 9 mm)
(other ranges available) |
Sample Thickness
Electronic-Measurement Accuracy |
+/- 1% of thickness reading
+/- 0.001 (25 micron)
(typical tolerance in hi-accuracy mode) |
Pre-heat Temperature Range
(for Phase Change Materials) |
35 °C - 70 °C |
| Supply Voltage |
100/115/220/230 VAC 50/60 Hz
(115 VAC, 60 Hz standard) |
| Dimensions (including test stage) |
22.5" H x 16.5" W x 17" D |
| Coolant Supply Requirements |
Flow Rate: 1.5 gal/min (6 liter/min)
Pressure Limit: 50 psi (350 kPa)
Temperature Control: +/- .1°C
Set Point Range: 10°C - 35°C, minimum
Cooling Capacity: 500 watts, minimum
|
| Compressed Air Supply |
Pressure Minimum: 90 psi (700 kPa)
Particulate Filtration: 10 micron |
| Weight |
60 lbs (27 kg) |
| Shipping Weight |
90 lbs (40 kg) |
Sample Size Note: The recommended sample size is 1.3" (33mm) diameter. Smaller diameter samples sizes can be tested although this requires a custom area adapter and yields test data with degraded accuracy specifications.
Sample Temperature Range Note: The range of sample temperatures depends on many factors, including the the chiller setpoint range and the thermal resistance of the sample. The above specified range assumes the use of the recommended chiller with a sample impedance greater than 0.2K/W. Chiller with higher maximum setpoints, will yield a higher maximum sample-temperature range. Samples with resistances less than 0.2K/W will have a lower maximum sample-temperature range. For a wider sample temperature range, the TIM Tester 1400 is recommended.
Contact Pressure Accuracy Note: The accuracy of the contact pressure control is based on the maximum contact pressure of the kit utilized for the maximum sample-area. Although the accuracy of the commanded-to-actual pressures is about +/-2.7% for all kits, the absolute accuracy of the contact pressure achieved will depend on the pressure range kit installed: the smaller the full-span of the kit, the better the absolute accuracy. Changing kits requires a simple hardware change and software parameter selection.
Ordering Information
Order number: Model 1300-Kx where "x" is the desired kit number. Standard delivery: 5 weeks, Ex Works.
Optional: 3 complete kit sets for user-installation of desired pressure range kit; order "TIM 1300-K4"
Specify AC Line voltage if other than 120 VAC. Custom orders welcome.
|
|
